SFP+-transceivermodule BlueOptics USFP+-192-S31-DL-BO 10000 Mbit/s

The BlueOptics USFP+-192-S31-DL-BO is an SFP+ fiber optic transceiver module designed for 10 Gbit/s links over single-mode fiber. The module is housed in metal for mechanical robustness, has a compact SFP+ form factor, and weighs approximately 20 g. With an MTBF of 1,000,000 hours, this transceiver is intended for use in high-speed network equipment that accepts SFP+ modules and LC duplex connectors for optical transmission and reception.

Advantages

This SFP+ transceiver supports data rates up to 10000 Mbit/s and follows Multi-Source Agreement (MSA) mechanical and electrical standards for plug-in optical modules. The metal housing provides mechanical stability and EMI resistance for typical installation environments. The specified MTBF indicates long operational life and reduces the need for frequent replacements. The module’s silver finish and compact design allow straightforward integration into switches, routers, storage systems and other SFP+-compatible hardware.

Suitable for

Key specifications

How to use

Ensure the host device supports SFP+ transceiver modules and the required optical specifications for 10 Gbit/s single-mode links. Insert the module into an SFP+ slot until it latches, then connect LC duplex single-mode fiber patch cords to the TX and RX ports according to the system’s labeling. Configure the host interface or switch port to the appropriate speed and protocol if manual settings are required. Verify link status and diagnostics through the host system once the fiber connections are in place.

Recommendations

For reliable operation, use single-mode LC duplex patch cords of appropriate attenuation and quality, and observe proper handling to avoid contamination of the optical interfaces. Confirm DDM/DOM support on the host device if remote digital diagnostics are needed. Follow vendor guidelines for hot-plugging SFP+ modules and perform connector cleaning procedures before insertion to maintain optical performance.