SFP+-transceivermodule BlueOptics RDH 102 50/3-BO 10000 Mbit/s

The BlueOptics RDH 102 50/3-BO SFP+ transceiver module is a compact 10GBASE-LR optical transceiver designed for single-mode fiber links. It supports a maximum data transfer rate of 10000 Mbit/s and uses an LC duplex connector for simultaneous transmit and receive over separate fibers. The module is supplied in a silver housing, weighs approximately 20 g, and follows SFP+ form-factor and MSA guidelines to ensure physical and electrical compatibility with SFP+ ports that accept 10GBASE-LR modules.

Advantages

This SFP+ transceiver provides support for long-reach single-mode connections up to typical 10 km ranges (10GBASE-LR) while maintaining a small SFP+ footprint. Built according to MSA specifications, the module is compatible with major hardware platforms that accept the 10GBASE-LR SFP+ standard. Compliance with CE, RoHS and FCC standards ensures conformity with common regulatory and safety requirements. Low weight and compact size simplify installation and replacement in racks and network devices.

Suitable for

Key specifications

How to use

Power down or follow hot-swap procedures required by your network equipment, then insert the BlueOptics RDH 102 50/3-BO into an available SFP+ port until it latches. Connect LC duplex single-mode fiber patch cords with correct polarity to the module's TX and RX interfaces. After insertion, check the host device for link negotiation and confirm the port is enabled and operating at 10 Gbit/s. If your device supports Digital Diagnostics Monitoring (DDM/DOM), enable and read diagnostic values through the host to monitor voltage, temperature, laser bias and optical power levels.

Recommendations

Use quality single-mode fiber and LC duplex patch cords, observe correct polarity and avoid bending fibers beyond recommended radii. Ensure the host device firmware or software supports third-party SFP+ modules and, where available, enable DDM/DOM monitoring for proactive diagnostics. Store spare modules in dust-free conditions and handle the LC connector ends with protective caps when not in use.