SFP-transceivermodule BlueOptics E1MG-TX-FY koper 1250 Mbit/s

The BlueOptics E1MG-TX-FY Copper SFP transceiver module supports a maximum data transfer rate of 1250 Mbit/s and is designed for use with standard SFP ports. This compact optical-electrical module enables copper-based network connections where an SFP interface is available, offering straightforward insertion into compatible switches, routers or media converters. The module is intended for high-speed serial data links and network upgrades that require a hot-pluggable SFP form factor.

Advantages

The transceiver provides a reliable copper connection in SFP bays with support for data rates up to 1250 Mbit/s. Its small SFP form factor allows easy replacement or addition without modifying system hardware. Compatibility with standard SFP interfaces ensures interoperability with a wide range of network equipment. The device is suitable for point-to-point links and short-range copper connections where fiber optics are not required.

Suitable for

Key specifications

How to use

Insert the BlueOptics SFP copper transceiver into an empty SFP slot on compatible network equipment until it clicks into place, then connect the copper cable to the module’s RJ-45 connector if present. Ensure the host device is powered and configured to recognize SFP modules; the link should negotiate at the supported rate automatically. For safe removal, disable the port or power down the device if required by the equipment vendor, then press the release latch and withdraw the module.

Recommendations

Use this module for short-range copper connections and ensure cable quality and pinout match the network requirements. Verify compatibility with the host device’s SFP firmware and confirm link settings after installation. Avoid exposure to excessive dust, moisture, or mechanical stress to maintain performance and service life.