SFP-transceivermodule BlueOptics BO05M13602D-BO 155 Mbit/s

The BlueOptics BO05M13602D-BO SFP transceiver module is a compact fiber optic module designed for 100BASE-FX applications with a maximum data transfer rate of 155 Mbit/s. Housed in an aluminium enclosure and weighing approximately 20 g, this SFP module uses an LC duplex connector and supports transmission over multimode fiber with 1310 nm optical wavelengths for both transmitter and receiver channels. The module follows MSA standards for mechanical and electrical compatibility, making it suitable for use in switches, routers and other networking devices that accept SFP transceivers.

Advantages

The BlueOptics BO05M13602D-BO offers standardized SFP form-factor compatibility and a lightweight, durable aluminium body that facilitates installation and removal in dense networking environments. It supports optical transmission at up to 155 Mbit/s over multimode fiber and uses LC duplex connectivity to enable simultaneous send and receive channels. The module is manufactured to industry MSA guidelines to ensure interoperability with a wide range of hardware platforms that support 100BASE-FX SFP modules.

Suitable for

Key specifications

How to use

Power down or follow hot-swap procedures recommended by the host device, insert the SFP module into a compatible SFP port until it clicks into place, and connect LC duplex fiber patch cords to the TX and RX ports ensuring proper polarity. Configure the host network device for 100BASE-FX operation if required by its interface settings. Verify link status and monitor the connection using the host devices management interface or supported diagnostic functions.

Recommendations

Use high-quality multimode LC duplex patch cords and maintain correct fiber polarity for best performance. Confirm that the target hardware supports 100BASE-FX SFP transceivers and any digital diagnostic functions before deployment. Handle the module by its housing, keep protective dust caps on unused fiber connectors, and follow ESD precautions during installation.