SFP-transceivermodule BlueOptics 3HE04524AA-BO glasvezel 155 Mbit/s

The BlueOptics 3HE04524AA-BO Fiber optic SFP transceiver module provides 155 Mbit/s optical data transmission over standard single-mode or multimode fiber links. Designed to comply with SFP interface standards, this compact module supports point-to-point connections in telecommunications equipment and network devices. It is intended for integration into switches, routers and fiber line cards where a small-form-factor pluggable transceiver is required to deliver stable optical connectivity at the specified data rate.

Advantages

This SFP transceiver offers a standardized SFP interface for hot-pluggable installation, minimizing downtime during equipment upgrades or replacements. With a defined maximum data transfer rate of 155 Mbit/s, it ensures predictable throughput for legacy SDH/SONET or PDH applications and lower-speed fiber links. The compact form factor and compatibility with common SFP ports allow flexible deployment in dense networking racks and telecom platforms.

Suitable for

• Telecommunications links requiring 155 Mbit/s optical transmission
• Network switches and routers with SFP ports
• Data center uplinks and fiber backbone segments at defined low-rate links
• Point-to-point fiber connections in legacy or industrial networks

Key specifications

• Interface type: SFP (Small Form-factor Pluggable)
• Maximum data transfer rate: 155 Mbit/s
• Form factor: compact SFP module for hot-pluggable installation
• Media: fiber optic transmission (single-mode or multimode compatibility depends on system)
• Typical application: low-rate optical links in telecom and networking equipment

How to use

Insert the BlueOptics SFP module into a compatible SFP port on the target switch, router or fiber interface card while the host device is powered on or following the equipment manufacturer’s hot-swap guidance. Connect the appropriate fiber patch cable to the module’s optical port following correct polarity and connector type used in your installation. Verify link status through the host device management interface and ensure the device is configured for the intended 155 Mbit/s operation. Observe standard ESD precautions when handling the module and protect the optical connector with dust caps when not connected.

Recommendations

Use certified fiber patch cables and confirm that the host equipment supports 155 Mbit/s SFP modules. Check compatibility with the optical fiber type and connector standard in your infrastructure and perform link tests after installation to validate signal quality and error rates.