RCA-stekker ShiverPeaks BS51400-W

The ShiverPeaks BS51400-W RCA Connector is a single male RCA plug designed for reliable audio and video signal transmission. Finished in white, this connector is intended for use where a discreet, clean appearance is required and where a secure, low-resistance connection is important. The connector is supplied as a single unit and is compatible with standard RCA sockets found on home audio equipment, TVs, amplifiers and other consumer electronics.

Advantages

This RCA connector offers a compact design with straightforward installation and a consistent mechanical fit for standard RCA ports. Its construction provides reliable conductivity for audio and video signals and a finish that matches white cables or devices. Supplied as a single male plug, it is suitable for replacing damaged plugs or for single-cable terminations where a clean, colour-matched connector is required.

Suitable for

• Connecting audio components such as CD players, DACs and amplifiers
• Terminating composite video cables for TVs and video devices
• Repairing or replacing a single RCA plug on existing cables
• Home theatre and stereo system installations where white connectors are preferred

Key specifications

• Connector type: Male RCA (phono) plug
• Colour: White exterior finish
• Pack quantity: 1 unit
• Compatibility: Standard RCA sockets on audio/video equipment
• Function: Analogue audio and composite video signal transmission

How to use

Strip the cable to expose the conductor and shield according to the connector's intended assembly method, insert the centre conductor into the signal pin and secure the shield to the outer contact. Ensure a snug mechanical fit by tightening or crimping the connector as designed, and verify there is no short between the signal and ground. After assembly, plug the connector into the device's RCA socket until it seats firmly and check audio or video signal continuity.

Recommendations

Use appropriate cable preparation tools and follow the connector manufacturer's assembly instructions to ensure reliable electrical contact. Avoid excessive bending or mechanical stress near the termination point and inspect the connection if signal degradation or noise appears.