LED-strip Cablemod CM-LED-60-D60RGBW-R

The CableMod CM-LED-60-D60RGBW-R is a 0.6 m LED strip designed for computer cases, combining RGB and dedicated white LEDs on a single black strip to provide customizable color effects and accurate white tones. It is compatible with GIGABYTE RGB Fusion Technology and is supplied with mounting options for magnetic and non-magnetic surfaces. The strip is lightweight (approx. 100 g) and intended to enhance internal PC lighting with controllable RGBW illumination.

Advantages

This LED strip uses separate white LEDs alongside RGB diodes to produce brighter and truer whites than combination RGBW bulbs. Compatibility with GIGABYTE RGB Fusion allows synchronized lighting with supported motherboards and peripherals. For flexible installation, the strip includes embedded rare-earth magnets under a waterproof coating for attachment to steel or other magnetic surfaces, plus a strong 3M adhesive for non-magnetic cases.

Suitable for

• Lighting interior of PC cases
• Custom gaming and workstation builds
• Systems requiring synchronized RGB lighting (GIGABYTE RGB Fusion)
• Installations on both magnetic and non-magnetic surfaces

Key specifications

• Model: CableMod CM-LED-60-D60RGBW-R
• Length: 0.6 m
• Color: Black strip with RGB and dedicated white LEDs
• Weight: approx. 100 g
• Compatibility: GIGABYTE RGB Fusion Technology
• Mounting: embedded rare-earth magnets and 3M adhesive

How to use

Connect the LED strip to a compatible RGBW header or controller according to your motherboard or controller manual, then place the strip inside the PC case where lighting is desired. For magnetic surfaces, align the strip so the embedded magnets contact the metal; for non-magnetic surfaces, remove the protective liner and press the strip in place using the supplied 3M adhesive. Configure colors and effects via GIGABYTE RGB Fusion or your compatible controller software.

Recommendations

Avoid placing the strip near components that produce excessive heat and ensure connectors are properly seated before powering the system. When using the adhesive, clean the surface of dust and oils for best adhesion; allow the adhesive to set before moving the case.