Keystone-module plat ShiverPeaks BS08-10030-8

The ShiverPeaks BS08-10030-8 flat keystone module is a compact RJ-45 insert designed for structured cabling. With a silver finish and a flat profile, this module integrates into wall plates and patch panels to provide a standard Ethernet interface. Sold in packs of eight, it supports straightforward installation and reliable RJ-45 connections for residential and commercial network deployments.

Advantages

The flat form factor reduces protrusion behind faceplates and helps maintain a low-profile installation in shallow boxes and modular panels. The silver finish offers a neutral appearance that complements typical faceplates and mounting frames. Each module provides a standard RJ-45 interface for compatibility with common patch cords and networking devices, and the multi-pack format ensures consistent performance across multiple terminations.

Suitable for

• Structured cabling in homes and small offices
• Multi-room network installations and data points
• Patch panels and modular wall plates requiring low-profile inserts
• Renovation projects where shallow back boxes are present

Key specifications

• Connector type: RJ-45 jack (female)
• Form factor: flat / low-profile keystone module
• Finish: silver-colored housing
• Pack quantity: 8 modules per pack
• Compatibility: designed for standard keystone openings and faceplates

How to use

Insert the flat keystone module into a compatible keystone opening in a faceplate or patch panel until it snaps into place. Terminate the incoming copper cable to the module according to the chosen wiring scheme (T568A or T568B), observing cable preparation and pair alignment practices for reliable contacts. After termination, secure the faceplate or panel and connect an RJ-45 patch cord to the module to verify link status and network connectivity.

Recommendations

When installing multiple modules, use consistent wiring (T568A or T568B) across the installation, keep cable twists intact up to the termination point, and test each connection with a cable tester to confirm continuity and correct pairing before finalizing wall plates or panels.