InLine RCA audio via LAN / Ethernet / RJ45-kabel max. 50m compleetset

The InLine RCA Audio over LAN Ethernet RJ45 Cable max 50m complete set enables transmission of analog audio signals over structured cabling using an RJ45 connection. The complete set includes adapters and a 0.1 m patch cable in black, allowing audio to be routed across distances up to 50 metres without the need for active network devices.

Advantages

This adapter set carries stereo RCA (or 3.5 mm) audio signals through standard Ethernet cabling, simplifying installation when running audio between rooms. The passive solution requires no power or network switching equipment and supports reliable short- to medium-range audio transport up to 50 m. Compact black components fit into most setups and are easy to connect to existing RCA or 3.5 mm sources and RJ-45 wall ports or patch panels.

Suitable for (tasks / use cases)

Key specifications

How to use

Connect the RCA (or 3.5 mm) plug from your audio source to the adapter, then insert an RJ-45 plug into the corresponding adapter end. Use standard Cat5/Cat6 cabling or patch panels to route the signal to the receiving adapter at the destination. Finally, connect the receiving adapter back to the target device’s RCA or 3.5 mm input. Ensure cable runs do not exceed 50 metres for passive transmission.

Recommendations

For best results, use unshielded or shielded Cat5e/Cat6 cable in good condition, keep audio runs below the maximum distance, and avoid bundling audio lines with high-voltage power cables to reduce interference.