HP kabel 12 SATAENV ST-Reverse RA

For tight internal builds where a standard straight SATA connector would collide with drive cages or chassis walls, this HP M10484-001 cable routes cleanly with a reverse right-angle on the device end. The 12-inch length keeps signal paths short while still allowing tidy routing between motherboard and storage.

Highlights

• SATA III 6Gb/s data transfer for modern HDDs, SSDs, and optical drives
• Straight SATA 7-pin to reverse right-angle SATA 7-pin connectors
• Latching connectors prevent accidental disconnection
• Foil and braid shielding reduces electromagnetic interference
• Tinned copper conductors and durable PVC jacket
• RoHS compliant, 5V rating, wide operating temperature range

In daily use

The reverse right-angle connector is particularly useful when the SATA port on your drive faces the side panel or a nearby bracket. Instead of forcing a straight cable into a sharp bend, the 90-degree exit keeps the cable flat and stress-free. Both ends latch securely, so vibration from spinning drives or case movement won't loosen the connection over time. At 12 inches, it bridges typical motherboard-to-drive distances without excess slack that could obstruct airflow.

Full specifications

• Cable type: SATA data cable
• Connector 1: SATA 7-pin male, straight
• Connector 2: SATA 7-pin male, reverse right-angle (90°)
• Length: 12 inches (approx. 30.5 cm)
• Data transfer standard: SATA III (6 Gb/s), backward compatible with SATA II (3 Gb/s) and SATA I (1.5 Gb/s)
• Latching connectors: Yes
• Conductor material: Tinned copper
• Jacket material: PVC
• Shielding: Foil and braid
• Colour: Black
• Voltage rating: 5V
• Operating temperature: -20°C to 80°C
• RoHS compliant: Yes
• Application: Internal PC data connection for HDD, SSD, optical drives

Final note

An OEM-grade SATA cable that solves clearance problems without sacrificing performance or reliability.