DEXLAN glasvezel-lasmof 40 mm (395413)

This splice protector stands out with its integrated stainless steel strength member, which reinforces the splice point against bending and tension—a detail often missing in basic heat-shrink sleeves. The 40 mm length is matched to standard fusion splice trays, and the transparent polyolefin tube lets you visually confirm the splice is centered before shrinking.

Highlights

• Stainless steel strength member adds mechanical stability to the splice
• Hot-melt adhesive seals the splice against moisture and dust
• Transparent tube allows visual alignment check before shrinking
• Shrink ratio approx. 2:1 for a tight, uniform fit

In daily use

Slide the protector over the bare fusion splice, position it centrally, and apply heat from 90°C to 120°C. The outer tube shrinks down to 3.5 mm diameter while the inner adhesive flows to encapsulate the fiber. Once cooled, the splice is protected from mechanical stress, humidity, and dust, and can be safely placed in splice trays or closures. The protector works with both single-mode and multi-mode fibers.

Full specifications

• Length: 40 mm
• Outer diameter after shrinking: 3.5 mm
• Inner diameter before shrinking: 3.0 mm
• Inner diameter after shrinking: 2.5 mm
• Strength member material: Stainless steel
• Strength member diameter: 1.0 mm
• Outer tube material: Polyolefin
• Adhesive material: Hot-melt adhesive
• Shrink ratio: Approx. 2:1
• Operating temperature range: -45°C to +100°C
• Shrink temperature: 90°C to 120°C
• Color: Transparent
• Application: Protection of single fiber fusion splices
• Compatibility: Single-mode and multi-mode optical fibers
• Environmental protection: Mechanical, moisture, and dust protection
• Durability: High resistance to heat, cold, and humidity
• Typical fiber count: 1
• Installation method: Heat shrink

Final note

Designed for single-fiber fusion splices, this protector ensures long-term reliability in both indoor and outdoor fiber optic networks.