Afdichting KS Tools 970.0760

The KS Tools 970.0760 gasket is a precision-manufactured sealing component intended for reliable leak prevention in mechanical assemblies. With a mass of approximately 340 g, this gasket is engineered to provide consistent compression and a secure seal between mating surfaces in both automotive and industrial equipment. Its construction focuses on durability and dimensional stability to maintain sealing performance under typical operating conditions.

Advantages

This gasket delivers consistent sealing performance through stable material properties and accurate dimensions, reducing the chance of fluid or gas leaks. Its weight and build contribute to reliable compression behavior, while compatibility with common engine and machinery interfaces simplifies installation and replacement. The gasket's design helps maintain system efficiency by preventing contamination and loss of pressure in sealed joints.

Suitable for

• Automotive engine and transmission sealing points
• Industrial pumps and compressors
• Hydraulic and pneumatic systems requiring flat gasket seals
• Repair and maintenance tasks where a robust, replaceable seal is needed

Key specifications

• Approximate weight: 340 g
• Application: sealing between flat mating surfaces in engines and machinery
• Material characteristics: engineered for compression stability and durability
• Typical operating conditions: suitable for common automotive and industrial temperature and pressure ranges

How to use

Clean and inspect both mating surfaces to remove old gasket material, debris, and oil residues before fitting the gasket. Position the gasket accurately on the flange or housing and align bolt holes or locating features. Tighten fasteners progressively and in a crisscross pattern to the manufacturer-recommended torque to achieve even compression. After initial installation, recheck torque values once the system reaches operating temperature if required by the equipment manufacturer.

Recommendations

Store the gasket flat in a dry environment to avoid deformation. Replace the gasket if it shows signs of wear, compression set, cracks, or contamination. Use gasket sealants only if specified by the equipment manufacturer; unnecessary sealant may affect sealing performance. For critical systems, follow the service manual for torque sequences, fastener grades, and any required break-in procedures.