2-Power AC-voeding 2A inclusief netsnoer (2P-P000556560)

For devices that demand a steady 12V DC supply without the bulk of a fixed-cord brick, this 2-Power adapter separates the AC input from the DC output with a detachable figure-8 cable, so you can swap in a longer mains lead or replace a damaged one without discarding the whole unit. Its 2A current rating and 24W output are matched to a 5.5 x 2.1 mm barrel plug, the most common size for small electronics, and the Level VI efficiency rating keeps wasted energy low even when the adapter is left plugged in overnight.

Highlights

• Universal 100–240V input works on any mains voltage, no transformer needed
• Detachable IEC C8 power cable included (1.2 m) for easy storage and replacement
• 5.5 x 2.1 mm centre-positive barrel connector fits a wide range of 12V devices
• Level VI efficiency reduces standby power draw and heat generation
• Built-in over-voltage, over-current, and short-circuit protection safeguards connected equipment

In daily use

The adapter runs cool and quiet thanks to its ABS housing and efficient switching design. The 1.2 m DC cable gives you enough reach to place the adapter on a desk or floor without stretching, and the black finish blends into any setup. Because the AC cable is a standard figure-8 type, you can use a longer cord from a printer or monitor if you need extra distance from the wall socket. The barrel plug’s 5.5 mm outer diameter and 2.1 mm inner diameter are the industry default for 12V routers, LED strips, and small peripherals, so this adapter often works as a direct replacement for lost or failed power supplies.

Full specifications

• Input voltage: AC 100–240 V, 50/60 Hz
• Output voltage: DC 12 V
• Output current: 2 A
• Output power: 24 W
• DC connector: 5.5 mm x 2.1 mm barrel plug
• AC input connector: IEC C8 (figure-8)
• AC power cable included: Yes, 1.2 m
• DC output cable length: 1.2 m
• Efficiency rating: Level VI
• Protection: OVP, OCP, SCP
• Certifications: CE, FCC, RoHS
• Colour: Black
• Housing material: ABS plastic
• Operating temperature: 0 °C to 40 °C
• Storage temperature: -20 °C to 85 °C
• Humidity: 10% to 90% RH (non-condensing)
• Number of outputs: 1

Final note

Before ordering, confirm that your device requires 12V DC and draws no more than 2A. The centre-positive polarity is standard, but always check the label on your original adapter to avoid mismatch.