XLR-luidsprekerkabel PSSO 2x2,5 mm 10 m zwart

The PSSO XLR speaker cable 2x2.5 mm, 10 m in black is a flexible audio connection cable designed to transmit balanced signals between amplifiers, mixers and speakers. With twin conductors of 2.5 mm² cross-section and an overall shielded construction, this cable is intended for stage and studio use as well as permanent installations where consistent signal transfer and mechanical durability are required.

Advantages

The cable combines a twin 2.5 mm² conductor layout with an outer sheath that resists abrasion and bending, providing stable low-loss transmission for professional audio setups. Its flexible design allows neat routing and reliable connections in tight spaces. Shielding and conductor geometry reduce interference and keep signal integrity over the 10 m run, while the black finish blends unobtrusively into stage and installed environments.

Suitable for

Key specifications

How to use

Route the cable between source and load devices, avoiding tight bends and sharp edges. Use appropriate strain relief at connection points to prevent mechanical stress on the terminations. Connect the balanced XLR ends to the corresponding amplifier, mixer or speaker inputs following standard pin assignments for balanced audio. For permanent installations, secure the cable along runs with cable ties or clips and avoid running in parallel with power cables to minimise interference.

Recommendations

For best signal quality, keep run lengths as short as practical and maintain correct balanced wiring. Inspect the jacket and terminations regularly for wear; replace the cable if shielding or conductors become exposed. When used on stage, coil and store the cable properly to extend service life.