Lenovo 720HD 5M11B95344 webcammodule — 720p HD-resolutie

Replacement camera assembly for Lenovo laptops designed to provide 720p HD resolution for video calls and basic imaging needs. This direct-fit OEM component restores an integrated webcam's function by matching the original mounting and connection points on compatible Lenovo models. The module is intended for use where a factory-equivalent webcam is required to regain full video functionality for online meetings, remote learning and casual streaming.

Advantages

This Lenovo webcam assembly delivers native 720p HD video, enabling clear image capture and smooth video conferencing on supported laptops. As a direct-fit replacement, it reduces installation complexity by aligning with original mounting brackets and connector types, which helps maintain the laptop's aesthetic and mechanical integrity. The part is optimized for basic imaging tasks and low-bandwidth environments, offering stable visual performance without requiring advanced configuration.

Suitable for

• Restoring webcam functionality in compatible Lenovo laptops
• Online video conferencing and virtual meetings
• Remote learning and video-based classes
• Casual streaming and video calls
• Repair shops and technicians performing OEM replacements

Key specifications

• Optical resolution: 1280 x 720 pixels (720p HD)
• Form factor: integrated laptop camera assembly designed for direct replacement
• Connection type: internal ribbon or board connector compatible with original laptop interface
• Typical mounting: matches integrated bezel and screw points for OEM fit
• Primary use: video capture for conferencing, streaming and imaging

How to use

Power down the laptop, disconnect the battery if accessible and open the display bezel following manufacturer service instructions. Remove the defective camera module and disconnect the internal cable carefully. Install the replacement camera assembly by seating it in the original mounting location and reconnecting the internal cable to the motherboard or camera board. Reassemble the bezel and reconnect the battery. After powering on, verify camera detection in the operating system and install any required drivers or camera utilities if the system does not automatically recognize the device.

Recommendations

Handle the camera assembly by its edges, avoid touching the lens surface and use ESD precautions during installation. If the camera is not detected after installation, check the cable seating and system privacy settings, and update or reinstall camera drivers from official Lenovo support resources.